Siding Contractors in Dix Hills, NY

A Siding Contractor Who Understands Dix Hills Lots

Dix Hills is the big-lot hamlet of the Town of Huntington. Zoning kept most parcels at half an acre or more, so the houses built from the 1950s through the 1990s are long ranches, wide splits, and oversized colonials with a lot of wall for a crew to cover. Older cedar and clapboard shows up in the Half Hollow area and near Vanderbilt Parkway, while the later subdivisions are mostly original vinyl or aluminum that has reached the end of its life. AP Siding & Windows installs insulated vinyl, horizontal lap, vinyl shake, cedar shake, board and batten, and fiber cement at Dix Hills scale.

There is no waterfront in Dix Hills, but the hamlet sits on the high ground of the Ronkonkoma moraine, and the rolling lots between the Northern State and the LIE catch more wind than the flat land to the south. Big mature oaks on the older streets keep north and east walls in shade, and we find damp sheathing behind failed siding there more often than homeowners expect. Open south walls on the newer developments get heavy sun. We match the wall assembly to the exposure, which means insulated or heavier-gauge vinyl on sunny faces and attention to drainage and ventilation on the shaded ones.

Siding services we provide in Dix Hills

Siding replacement

Full tear-off to sheathing, repair of anything we find underneath, new water-resistive barrier, and new siding with trim. This is most of our Dix Hills work.

Siding repair

Storm damage, cracked or loose panels, and rot behind the siding. Worth doing when the rest of the wall has life left in it, and worth being honest about when it does not.

Insulated vinyl siding

Contoured foam backing that adds R-value across the studs, stiffens the panel and cuts outside noise.

Fiber cement siding

James Hardie and similar. The choice where profile and trim detail have to look right.

Cedar and cedar-profile siding

Natural cedar shake and clapboard for period homes, plus cedar-look vinyl and composite when you want the appearance without the maintenance.

Trim, soffit, fascia and gutters

Aluminum trim wrap on windows and doors, plus new soffit and fascia so the whole exterior finishes at the same time rather than in two visits a year apart.

What we would put on a Dix Hills house

• Fiber cement is the choice for the colonials and for the older houses where profile and trim detail have to look right. It holds a painted finish for years, will not soften in summer heat, and carries a Class A fire rating. It is heavier and needs a flat, sound nailing surface, which is part of why we tear off rather than go over.
• Insulated vinyl is what we recommend most often here, because it suits the post-war stock this town is full of. These houses were framed 2x4 with thin wall insulation, and the contoured foam backing adds R-value across the studs where the framing normally bleeds heat straight out. It also stiffens the panel, which matters on the long flat runs of a ranch or split where standard vinyl can read wavy.
• Standard vinyl still does the job on a defined budget, and modern fade-resistant panels in the right profile look considerably better than what went on these houses in 1991. On the shaded lots we will steer you away from the palest colours, because that is where the green cast shows worst.

What siding costs in Dix Hills

We do not quote over the phone, because phone numbers change once somebody actually looks at the house, and that is how homeowners end up with a price that moves after the contract is signed. What we can tell you is what drives the number.

Square footage and elevation count

A cape with four simple elevations prices very differently from a split level with dormers, gable returns and a bump-out.

Material

Standard vinyl, insulated vinyl and fiber cement sit at three different price points, and the gap widens on larger houses.

What is behind the old siding

On houses that were re-sided over the original material in the 80s or 90s, there is a real chance of sheathing repair once we tear off. We open a section during the estimate specifically so it does not become a change order later.

Trim scope

Whether you wrap the windows and doors and replace soffit and fascia at the same time. Doing it together costs less than doing it twice.

You get an itemized written price after we measure on site, and it does not change unless you change the scope.

Permits for siding work in Dix Hills

Exterior work here permits through the Town of Huntington, at Town Hall on Main Street. A building permit covers alteration and repair of a structure, and siding replacement sits inside that.

The part most homeowners do not know: the Town does not handle permits for the four incorporated villages inside its borders. Asharoken, Huntington Bay, Lloyd Harbor and Northport each have their own building officials and their own process. All four sit on the north shore coastline, so if your property is anywhere near the water it is worth confirming which side of a village line you are on before anyone files anything.

Huntington also runs an Architectural Review Board that looks at exterior changes in designated zones. It does not apply to most residential streets, but it does apply in parts of Huntington village, and finding that out after you have ordered material is an expensive way to learn it.

We confirm the jurisdiction for your address before we file. It takes five minutes and saves the kind of delay that pushes a spring job into summer.

How the job runs

1. One We come out, measure, and open a section of the existing siding so you can see what is behind it. No phone estimates.
2. Two You get an itemized written price with the material, colour, trim scope and expected schedule on it.
3. Three We confirm the permit authority for your address and file what is required.
4. Four Our own installers do the work. Tear-off to sheathing, any repairs, new water-resistive barrier, then siding and trim. Deliveries get staged neatly, the driveway stays usable, and we magnet-sweep for nails before we pull out each day.
5. Five Walkthrough with you before we call it finished.

Dix Hills at a Glance

ZIP

11746

Township

Town of Huntington

Permits

Town of Huntington Building Division

County

Suffolk County

Estimates

Free, in person, written price after measuring

Crew

In-house, based in East Northport

Dix Hills Neighborhoods and Roads

Deer Park Avenue and Vanderbilt Parkway run through the middle of the hamlet, and the streets off them hold the classic 60s ranches and splits on acre lots. The Half Hollow area to the west, near Half Hollow Road and the Melville line, has older homes and heavier woods. Around Dix Hills Park and the Caledonia Road section are 70s and 80s colonials. North toward Jericho Turnpike and the Elwood line the lots shrink a bit and the housing is earlier. South of the LIE toward Deer Park there are 50s developments on smaller parcels. Newer larger builds are scattered throughout on former farm and estate land.

Dix Hills from Jericho Turnpike to the LIE

We work across all of Dix Hills, from the Jericho Turnpike side near Elwood and Commack down through the Vanderbilt Parkway and Deer Park Avenue sections to the LIE and the Deer Park line, and west into Half Hollow. Melville, Commack, and Huntington Station are on the same route.

• Melville, NY
• Commack, NY
• Huntington Station, NY
• Elwood, NY
• Deer Park, NY
• East Northport, NY

Frequently asked questions

Why do siding quotes in Dix Hills tend to run higher than in nearby hamlets?

Mostly because the houses are bigger. A long Dix Hills ranch or a two-story colonial on an acre has far more wall area than a Huntington Station cape, and square footage is the first thing that drives price. Material choice, tear-off, and trim follow. Vinyl keeps the cost down, fiber cement raises it. We measure in person and give you a written number.

Does new siding in Dix Hills need a Town of Huntington permit?

Dix Hills is a hamlet, so any permit comes from the Town of Huntington Building Division. Swapping old siding for new of a similar type is generally exempt. If the job includes replacing sheathing, repairing framing, removing asbestos-cement shingle, or changing window sizes, the Town may want a filing. We confirm what your project needs and handle it as part of the job.

What siding do you recommend for a wooded Dix Hills lot?

The heavily treed streets near Half Hollow and Vanderbilt Parkway keep walls damp, so the priority is a product that drains and dries. Insulated vinyl with a proper house wrap behind it does well, and fiber cement is the upgrade if you want a painted finish. Cedar shake looks right on the older homes but needs upkeep in shade. For the sunny open lots, heavier vinyl resists fade.

How long does a Dix Hills siding project usually last?

The three-to-five working day range for vinyl applies to an average house, and many Dix Hills houses are above average in size, so plan for the longer end or a bit beyond on a large colonial. Fiber cement takes more time, and so does repair work behind old siding. Weather delays happen and we tell you the day we know. Your schedule is set after the measure.

Can you do windows and siding together on a Dix Hills ranch?

Yes, and the long ranches here with a row of original windows across the front are ideal for it. With the siding removed we can install double-hung, casement, slider, bay and bow, awning, basement, and custom-shape windows in vinyl or fiberglass and flash each one to the sheathing. The new siding then finishes tight to the frames. One crew, one project, one written price.

My Dix Hills house has old aluminum siding over cedar. Can you work with that?

It is a common setup on 60s homes here. We remove the aluminum and inspect the cedar beneath it. Sometimes it is sound enough to leave as a substrate under house wrap. Often there is rot at the corners and below windows that has to come out. We tell you what we found before new siding goes on, and the written estimate includes a repair allowance.

Why Dix Hills Homeowners Choose AP

• In-house crews. Large Dix Hills houses need a crew that stays on the job start to finish. Ours does, and nobody on it is a subcontractor.
• Written price after we measure. On an acre-lot colonial a guess can be off by thousands. We measure every wall and gable in person and put a firm price in writing.
• Based nearby in East Northport. Dix Hills is about 10 to 15 minutes from our shop down Larkfield Road and Deer Park Avenue, so we are close for the measure and any follow-up.