Siding Contractors in Port Jefferson, NY

Harbor-front Victorians to hillside splits, we side Port Jefferson homes under village rules, with a free written estimate.

  • Serving 11777
  • Based in East Northport
  • Licensed & insured
  • Own crews, no subs
  • (631) 972-0873

Siding Built for Port Jefferson's Harbor and Hills

Port Jefferson is a shipbuilding village, and its housing shows it. Down near the harbor and the Village Historic District the houses are 1800s captains' homes and workers' cottages, most of them wood-clapboard or cedar originally and many wrapped in aluminum or vinyl decades ago. Up the hill toward the station and out in Harbor Hills the stock shifts to post-war ranches, splits, and larger 70s and 80s colonials. AP Siding & Windows handles the full range. We install cedar shake, board and batten, fiber cement, vinyl shake, insulated vinyl, and horizontal lap, and we replace windows and roofs when the whole exterior is due.

The harbor shapes every exterior decision here. The lower village sits at sea level with the ferry channel to its north, so salt air and wet southwest wind reach the first few blocks of East Main and the streets below Hotel Square. Above the harbor the land climbs sharply, and the hilltop homes on Brick Hill and Cedar Hill take wind from every direction but dry out quickly. Shaded lots along the ravines stay damp. We match fastener grade, flashing detail, and material to where the house sits, and we expect to deal with old clapboard and uneven framing on anything built before 1900.

Siding services we provide in Port Jefferson

Siding replacement

Full tear-off to sheathing, repair of what we find underneath, new water-resistive barrier, new siding and trim.

Siding repair

Storm damage, cracked or loose panels, and rot behind the siding.

Insulated vinyl siding

Foam-backed panel that adds R-value across the studs and keeps long runs flat.

Fiber cement siding

James Hardie and similar, where profile and trim detail have to look right.

Cedar and cedar-profile siding

Natural shake and clapboard for period homes, or the look without the upkeep.

Trim, soffit, fascia and gutters

So the whole exterior finishes at once rather than in two visits a year apart.

What we would put on a Port Jefferson house

  • Cedar and cedar-profile siding Is the right answer on a lot of the older Port Jefferson houses. Natural shake and clapboard suit the period stock and the street; cedar-profile vinyl and composite give the look with less maintenance. This close to the water the fastener specification is as important as the material.
  • Fiber cement Is what we put on most Port Jefferson houses that take real Sound exposure. It holds a painted finish considerably longer in salt air than painted wood does and resists the chalking coastal air causes. It is heavier and needs a flat, sound nailing surface, which is part of why we tear off.
  • Standard vinyl Performs better near the water than people expect, since it has no painted finish to lose to salt air. What matters more on an exposed Port Jefferson house is the fastener specification and how the seaward elevation is detailed.

Permits for siding work in Port Jefferson

This is the one homeowners here get wrong, so it is worth being precise.

Port Jefferson is an incorporated village. The Town of Brookhaven does not issue your building permit. The Village has its own building department, its own fee schedule and its own review calendar, and a Town of Brookhaven application will not be accepted for a Village address. Belle Terre, immediately to the east, is a separate incorporated village again with its own building department.

We work on both sides of that line regularly and we confirm which authority covers your address before anything gets filed.

How the job runs

  1. One We measure on site and open a section of the existing siding so you can see what is behind it. No phone estimates.
  2. Two You get an itemized written price with material, colour, trim scope and schedule on it.
  3. Three We confirm the permit authority for your address and file what is required.
  4. Four Our own installers do the work. Tear-off to sheathing, repairs, new water-resistive barrier, then siding and trim. Driveway stays usable and we magnet-sweep for nails before we leave each day.
  5. Five Walkthrough with you before we call it finished.

Port Jefferson at a Glance

ZIP
11777
Township
Town of Brookhaven
Permits
Village of Port Jefferson Building Department
County
Suffolk County
Estimates
Free, in person, written price after measuring
Crew
In-house, based in East Northport

Where We Work in Port Jefferson

Lower Port, the blocks around East Main Street, Hotel Square, and Harborfront Park, holds the oldest homes in the village, including the Victorians near the Mather House. Brick Hill rises west of the harbor with a mix of 1800s houses and 1950s infill. Cedar Hill, around the cemetery and above the station, is capes and ranches from the post-war years. Upper Port along Main Street near the LIRR is smaller houses and rentals on tight lots. Harbor Hills in the northeast corner, around the country club and Mount Sinai Harbor, has the largest and newest homes on sloping, wooded parcels.

Port Jefferson Village and the Harbor Towns

Our crews cover the whole Incorporated Village, from the ferry dock to Harbor Hills and up to the station. Belle Terre, the separate village on the bluff, and Poquott across the harbor are on the same route, as are Port Jefferson Station, Mount Sinai, and the Setaukets.

All siding towns

Frequently asked questions

What will it cost to re-side an older house in Port Jefferson village?

Older harbor-area homes are hard to price without a visit. Many have irregular framing, tall gables, and a lot of trim, and some have two layers of old siding to strip. The number comes down to measured square footage, the material you choose, tear-off, and trim work. Vinyl is least expensive and fiber cement the most. The written price comes after we measure.

Does the Village of Port Jefferson require a permit for siding?

Port Jefferson is an incorporated village, so permits come from the Village of Port Jefferson Building Department, not Brookhaven Town. Like-for-like siding may not require one, but changes to windows, sheathing, or structure usually do, and homes in the Village Historic District can face additional review of visible exterior changes. We check with the village on your specific house before any work starts.

Which siding handles the harbor air in lower Port Jefferson?

The blocks nearest the water see salt and wet wind. Fiber cement holds paint well there and does not swell. Insulated vinyl is a solid lower-cost choice that will not corrode or rot. If you want a period look on a historic house, vinyl shake or cedar both work, but cedar near the harbor wants a sealed finish and more frequent attention.

How long will my Port Jefferson siding project take?

On a typical ranch or split in Cedar Hill or Harbor Hills, a vinyl job runs three to five working days. The historic homes near the harbor take longer because the walls are taller, the trim is more involved, and we usually find repairs once the old layer is off. Fiber cement adds days. We add village permit lead time to the schedule up front.

Can windows be replaced during a siding job in Port Jefferson?

Yes, and on the older village homes it is the best time to do it. With the walls open we can correct out-of-square openings, flash properly, and set double-hung, casement, bay and bow, slider, awning, or custom-shape windows in vinyl or fiberglass before the new siding goes on. One village application covers both, and one crew does the whole job.

My house is in the Port Jefferson Village Historic District. Does that change the job?

It can. The district around the lower village is on the National Register, and the village pays attention to exterior changes visible from the street. Material, profile, and trim choices may need to be in keeping with the house. We have worked on houses in districts like this, and we help you choose a product and a look that gets through review without a fight.

Why Port Jefferson Homeowners Choose AP

  • In-house crews. The crew that measures your Port Jefferson house is the crew that sides it. No subcontractors, which matters on old harbor homes where judgment calls happen daily.
  • Written price after we measure. Village homes vary too much to quote from the curb. We measure every wall, note the trim, and put a firm number in writing.
  • Based nearby in East Northport. Port Jefferson is about 35 minutes east of our shop along Route 25A, so a measure, a follow-up visit, or a punch-list stop is never a problem.

Get a Free Estimate · Call (631) 972-0873