Siding Contractors in Melville, NY

Siding Built for Melville's Bigger Homes

Melville is the southern edge of the Town of Huntington and it reads differently from the harbor hamlets. The housing is mostly 1970s through 2000s, with big center-hall colonials on half-acre lots, sprawling splits from the first wave of development, and a large share of condo and townhouse communities along Route 110 and Old Country Road. There is also older stock in the Sweet Hollow area. AP Siding & Windows works on all of it. We install insulated vinyl, horizontal lap, vinyl shake, board and batten, cedar shake, and fiber cement, and we are used to the larger wall areas and multi-gable rooflines that make up most of Melville.

Melville is fully inland, with no harbor or Sound exposure, so the siding challenges are sun, wind across open subdivision lots, and the tree cover in the older wooded sections near Sweet Hollow Road and West Hills County Park. South and west walls on the open 1980s streets take serious UV and benefit from heavier vinyl or fiber cement. The shaded lots to the north hold moisture and need a real drainage gap behind the siding. Condo communities add a different wrinkle, since the association often controls color and profile. We handle both the technical and the paperwork side.

Siding services we provide in Melville

Siding replacement

Full tear-off to sheathing, repair of anything we find underneath, new water-resistive barrier, and new siding with trim. This is most of our Melville work.

Siding repair

Storm damage, cracked or loose panels, and rot behind the siding. Worth doing when the rest of the wall has life left in it, and worth being honest about when it does not.

Insulated vinyl siding

Contoured foam backing that adds R-value across the studs, stiffens the panel and cuts outside noise.

Fiber cement siding

James Hardie and similar. The choice where profile and trim detail have to look right.

Cedar and cedar-profile siding

Natural cedar shake and clapboard for period homes, plus cedar-look vinyl and composite when you want the appearance without the maintenance.

Trim, soffit, fascia and gutters

Aluminum trim wrap on windows and doors, plus new soffit and fascia so the whole exterior finishes at the same time rather than in two visits a year apart.

What we would put on a Melville house

• Insulated vinyl is what we recommend most often here, because it suits the post-war stock this town is full of. These houses were framed 2x4 with thin wall insulation, and the contoured foam backing adds R-value across the studs where the framing normally bleeds heat straight out. It also stiffens the panel, which matters on the long flat runs of a ranch or split where standard vinyl can read wavy.
• Fiber cement is the choice for the colonials and for the older houses where profile and trim detail have to look right. It holds a painted finish for years, will not soften in summer heat, and carries a Class A fire rating. It is heavier and needs a flat, sound nailing surface, which is part of why we tear off rather than go over.
• Standard vinyl still does the job on a defined budget, and modern fade-resistant panels in the right profile look considerably better than what went on these houses in 1991. On the shaded lots we will steer you away from the palest colours, because that is where the green cast shows worst.

What siding costs in Melville

We do not quote over the phone, because phone numbers change once somebody actually looks at the house, and that is how homeowners end up with a price that moves after the contract is signed. What we can tell you is what drives the number.

Square footage and elevation count

A cape with four simple elevations prices very differently from a split level with dormers, gable returns and a bump-out.

Material

Standard vinyl, insulated vinyl and fiber cement sit at three different price points, and the gap widens on larger houses.

What is behind the old siding

On houses that were re-sided over the original material in the 80s or 90s, there is a real chance of sheathing repair once we tear off. We open a section during the estimate specifically so it does not become a change order later.

Trim scope

Whether you wrap the windows and doors and replace soffit and fascia at the same time. Doing it together costs less than doing it twice.

You get an itemized written price after we measure on site, and it does not change unless you change the scope.

Permits for siding work in Melville

Exterior work here permits through the Town of Huntington, at Town Hall on Main Street. A building permit covers alteration and repair of a structure, and siding replacement sits inside that.

The part most homeowners do not know: the Town does not handle permits for the four incorporated villages inside its borders. Asharoken, Huntington Bay, Lloyd Harbor and Northport each have their own building officials and their own process. All four sit on the north shore coastline, so if your property is anywhere near the water it is worth confirming which side of a village line you are on before anyone files anything.

Huntington also runs an Architectural Review Board that looks at exterior changes in designated zones. It does not apply to most residential streets, but it does apply in parts of Huntington village, and finding that out after you have ordered material is an expensive way to learn it.

We confirm the jurisdiction for your address before we file. It takes five minutes and saves the kind of delay that pushes a spring job into summer.

How the job runs

1. One We come out, measure, and open a section of the existing siding so you can see what is behind it. No phone estimates.
2. Two You get an itemized written price with the material, colour, trim scope and expected schedule on it.
3. Three We confirm the permit authority for your address and file what is required.
4. Four Our own installers do the work. Tear-off to sheathing, any repairs, new water-resistive barrier, then siding and trim. Deliveries get staged neatly, the driveway stays usable, and we magnet-sweep for nails before we pull out each day.
5. Five Walkthrough with you before we call it finished.

Melville at a Glance

ZIP

11747

Township

Town of Huntington

Permits

Town of Huntington Building Division

County

Suffolk County

Estimates

Free, in person, written price after measuring

Crew

In-house, based in East Northport

Melville Areas We Cover

The Sweet Hollow section north of the Northern State, near Sweet Hollow Road and the West Hills park trails, has the hamlet's oldest homes and the heaviest tree cover. South of the parkway, the 1970s and 80s developments around Old East Neck Road, Walt Whitman Road, and Pinelawn Road are big colonials and splits on wide lots. Along Route 110 and near the Republic Airport line are the condo and townhouse communities, including the 55-plus developments. The Half Hollow Hills area toward Dix Hills has larger newer homes. Closer to Old Country Road and the Farmingdale line the lots get smaller and the homes older.

Melville and the Route 110 Corridor

We serve all of Melville, from the Sweet Hollow and West Hills section down through the subdivisions south of the Northern State to the condo communities near Old Country Road and the airport. Dix Hills, Huntington Station, and Deer Park are on the same run, so our crews are in this part of the town most weeks.

• Dix Hills, NY
• Huntington Station, NY
• Deer Park, NY
• Huntington, NY
• North Babylon, NY
• Commack, NY

Frequently asked questions

How is siding priced on a large Melville colonial?

Melville houses tend to have more wall and more gables than the average Long Island home, and that is the main driver. We measure every elevation, then factor in the material, how many layers come off, and trim, soffit, and window wrap. Vinyl is the most economical and fiber cement the most expensive. The quote is a written figure after the measure, not a per-square guess.

Who handles siding permits in Melville?

Melville is an unincorporated hamlet, so the Town of Huntington Building Division is the permit office. Swapping siding for the same type of material is normally exempt. Sheathing replacement, structural repair, or new window openings may. If you live in a condo or HOA community along Route 110, the association usually has to approve material and color too, and we help with that submission.

What siding works best for an open, sunny Melville lot?

The 1980s subdivisions south of the Northern State have wide lots with little shade, so the south and west walls get full sun all afternoon. Insulated vinyl handles that better than standard panels because it lies flat and resists fade. Fiber cement is the premium choice for a crisp painted look. On the wooded Sweet Hollow lots we lean toward products with good drainage behind them.

How long does it take to re-side a home in Melville?

Because many Melville houses are large, a vinyl re-side here often runs toward the upper end of the usual three to five working days, and a big colonial with several gables can go past that. Fiber cement adds time. Condo projects depend on how many units are scheduled together. Rain is the main thing that moves the date, and we tell you right away when it does.

Can I bundle windows and siding on my Melville house?

Yes. Many 70s and 80s Melville homes still have their original wood or early aluminum windows, and replacing them with the siding off is the clean way to do it. We install double-hung, casement, bay and bow, slider, awning, basement, and custom-shape windows in vinyl or fiberglass, flash them to the sheathing, and run the siding tight to the frames in a single project.

I live in a Melville condo community. Can AP work within the HOA rules?

We do it regularly. Most Melville associations specify the siding profile and a short list of approved colors, and some require a formal application before work starts. We match the existing product where that is the rule, prepare the submission with samples and the written scope, and schedule around the community's hours. Your estimate reflects whatever the association requires.

Why Melville Homeowners Choose AP

• In-house crews. AP's own installers handle the big Melville colonials and the condo rows alike. The crew that measures is the crew that shows up.
• Written price after we measure. On a house with as much wall as a typical Melville colonial, we measure every elevation in person before putting a firm number in writing.
• Based nearby in East Northport. Melville is roughly 20 minutes south of our shop, down Route 110 or the Northern State. Close enough for a quick measure and a same-week start when the schedule allows.